Uniden AppCam 21 User Manual download pdf (Page 27)

This equipment has been tested and found to comply with limits for a Class B digital

device, pursuant to Part 15 of the FCC rules and ETSI (EN) 300328. These limits are

designed to provide reasonable protection against harmful interference in residential

installations. This equipment generates, uses, and can radiate radio frequency energy,

and if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to radio or television equipment

reception, which can be determined by turning the equipment o and on, the user

is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Move the equipment away from the monitor.

• Plug the equipment into an outlet on a circuit dierent from that to which the

monitor is connected.

• Consult the dealer or an experienced radio/television technician for additional

suggestions.

CAUTION! Any changes or modifications to this equipment not expressly

approved by the party responsible for compliance could void your authority to

operate the equipment.

RF Exposure Information

The antenna used for this transmitter must be installed to provide a separation

distance of at least 20 cm (7.9”) from all persons and must not be collocated or

operating in conjunction with any other antenna or transmitter.

IC COMPLIANCE INFORMATION

Radio Equipment Notice

The term “IC:” before the radio certication number only signies that Industry

Canada technical specications were met. Operation is subject to the following two

conditions: (1) this device may not cause interference, and (2) this device must accept

1 2 ... 22 23 24 25 26 27 28 29 30

No comments

Uniden AppCam 21 User Manual Page 27