Uniden Grant XL Specifications Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
_h_- -.-
11. NB and ANL Switch - Activates noise reduction circuitry. At the ANL (Automatic
Noise Limiter) position, only ANL circuitry is activated in the audio to reduce
background white noise. At the NB/ANL position, this switch activates both the
ANL and NB (Noise Blanker) circuitry in the receiver. The NB circuitry is very
effective for repetitive impulse noise, such as ignition noise. In the OFFposition,
NB and ANL circuits are deactivated.
12. CBlPA Switch- For normal CB operation, keep this switch at the CBposition. If
you connect a PA (Public Address) speaker (optional) to the PA. SP. Jack on the
rear panel, set the switch to the PA position. This enables you to use the radio as a
public address system. In PA mode, your voice will be heard through the PA
speaker. Also, all incoming signals will be heard through the PA speaker. This
allows you to monitor your channel activity while you are outside your vehicle.
Adjust the PA speaker output volume with the Microphone Gain Control.
13. HIILOW Switch - This switch allows you to select the tone of the receiving voice
in the audio. The LOW position increases bass. The HI position increases treble.
14. BRTIDIMSwitch - This switch allows you to change the brightness of the channel
LED and meter lighting. The DIM position lowers the brightness, and may be more
suitable for night driving.
15. Rxn'XIndicator- This 2-color LED lights to indicate the RX (receivemode) or
TX (transmit mode). The LED is GREENfor RX, and RED for TX. The LED turns
off when pressing the microphone PTT Switch in the PA mode.
16. Channel Readout - This bright LED displays the selected chamiel number.
Microphone Jack - Connect the microphone to this jack in order to operate either the
receiver or transmitter. If the microphone is not connected, you will hear no audio from
the speaker.
Microphone - Set the Microphone Gain Control to the full clockwise position. Press
and hold the PTT (push-to-talk) Switch, and hold the microphone several inches away
from your mouth. Speak into the microphone clearly in a normal voice. When you are
fmished talking, release the PTT Switch immediately toreceive the responding trans-
mission.
-5-
T
f
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comments to this Manuals

No comments