Uniden DECT1363 User's Guide download pdf (Page 7)

English - 7

x As part of our commitment to protecting our environment

and conserving natural resources,

Uniden voluntarily participates in

an RBRC

industry program to

collect and recycle used Ni-MH

batteries within the United States.

Please call 1-800-8-BATTERY for

information on Ni-MH battery

recycling in your area. (RBRC

a registered trademark of the

Rechargeable Battery Recycling

Corporation.)

Rechargeable batteries must be recycled or disposed

of properly.

Warning! The cords on this product and/or accessories

contain lead, a chemical known to the state of California

to cause birth defects or other reproductive harm. Wash

hands after handling.

Uniden works to reduce lead content in PVC coated

cords in our products and accessories.

COMPLIANCE INFORMATION

FCC Part 68 Informaon

This equipment complies with Part 68 of the FCC rules and

the requirements adopted by the ACTA. On the bottom of this

equipment is a label that contains, among other information,

a product identifier in the format US: AAAEQ##TXXXX. If

requested, this number must be provided to the phone company.

An applicable Universal Service Order Codes (USOC)

certification for the jacks used in this equipment is provided (i.e.,

RJ11C) in the packaging with each piece of approved terminal

equipment. A plug and jack used to connect this equipment to

the premises wiring and telephone network must comply with

the applicable FCC Part 68 rules and requirements adopted by

the ACTA. A compliant telephone cord and modular plug is

provided with this product. It is designed to be connected to a

compatible modular jack that is also compliant. See installation

instructions for details.

The REN is used to determine the number of devices that may

be connected to a phone line. Excessive RENs on a phone line

may result in devices not ringing in response to an incoming call.

In most but not all areas, the sum of RENs should not exceed

five (5.0). To be certain of the number of devices that may be

connected to a line, as determined by the total RENs, contact

the telephone provider. The REN for this product is part of the

product identifier that has the format US:AAAEQ##TXXXX.

The digits represented by ## are the REN without a decimal

point (e.g., 03 is a REN of 0.3).

If this equipment causes harm to the telephone network, the

telephone company will notify you in advance that temporary

discontinuance of service may be required. But if advance

notice isn't practical, the telephone company will notify the

customer as soon as possible. Also, you will be advised of

your right to file a complaint with the FCC if you believe it is

necessary. The telephone company may make changes in its

facilities, equipment, operations or procedures that could affect

the operation of the equipment. If this happens the telephone

company will provide advance notice in order for you to make

necessary modifications to maintain uninterrupted service.

Please follow instructions for repairing, if any (e.g. battery

replacement section); otherwise do not substitute or repair

any parts of the device except as specified in this manual.

Connection to party line service is subject to state tariffs. Contact

the state public utility commission, public service commission

or corporation commission for information. This equipment is

hearing aid compatible.

If you experience trouble with this equipment, contact the

manufacturer or an authorized agent. If the equipment is causing

harm to the telephone network, the telephone company may

request that you disconnect the equipment until the problem

is resolved.

If your home has wired alarm equipment connected to a phone

line, be sure that installing the system does not disable your

alarm equipment. If you have questions about what will disable

alarm equipment, contact your telephone company or a qualified

installer.

Any changes or modifications to this product not expressly

approved by the manufacturer or other party responsible for

compliance could void your authority to operate this product.

NOTICE: According to telephone company reports, AC

electrical surges, typically resulting from lightning strikes, are

very destructive to telephone equipment connected to AC power

sources. To minimize damage from these types of surges, a surge

arrestor is recommended.

FCC Part 15 Informaon

This device complies with part 15 of the FCC rules. Operation

is subject to the following two conditions: (1) This device may

not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause

undesired operation. Privacy of communications may not be

ensured when using this phone.

FCC PART 15.105(b): Note: This equipment has been tested

and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

x Reorient or relocate the receiving antenna.

x Increase the separation between the equipment and receiver.

x Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

x Consult the dealer or an experienced radio/TV technician

for help.

RF Exposure Informaon

This product complies with FCC radiation exposure limits under

the following conditions:

x The base must be placed to allow a minimum of 20 cm (8 inches)

between the antenna and all persons during normal operation.

x The base must not be collocated or operated in conjunction with

any other antenna or transmitter.

x The handset is designed for body-worn operation and meets

FCC RF exposure guidelines when used with any belt clip,

carrying case, or other accessory supplied with this product. (All

necessary accessories are included in the package; any additional

or optional accessories are not required for compliance with

the guidelines.) Third party accessories (unless approved by the

manufacturer) should be avoided as these might not comply with

FCC RF exposure guidelines.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Uniden DECT1363 User's Guide Page 7

Comments to this Manuals

Related products and manuals for Telephones Uniden DECT1363