Sheet 4
3) Installing the Phone
Choosing the Best Location
Before choosing a location for your new phone, here are some important
guidelines you should consider:
Avoid television sets and
other electronic equipment
Choose a
central location
Avoid microwave ovens
Avoid excessive
moisture, extremely
low temperatures, dust,
mechanical vibration,
or shock
Avoid
personal computers
Avoid other
cordless telephones
Avoid heat sources, such as
radiators, air ducts, and sunlight
Avoid noise sources such as a
window by a street with heavy traffic
Choose a location close to both a phone jack and a continuous power
outlet (one which is not connected to a switch).
Keep the base and handsets away from sources of electrical noise such as
motors, microwave ovens, and uorescent lighting.
For better reception, place the base as high as possible. You can place the
base on a desk or table top or mount it on the wall.
Place the base in an open area for optimum range and reception.
If your home has specially wired alarm equipment connected to the
telephone line, be sure that installing the system does not disable your
alarm equipment. If you have questions about what will disable your alarm
equipment, contact your telephone company or a qualied installer.
Installing the Battery
Note: Use only the Uniden BT-1006 rechargeable battery pack
supplied with your phone.
1
Press down
Remove the cover.
2
Connect the battery pack
with the correct polarity.
Use the finger
indention for
a better grip
The connector notches
fit only one way.
Slide the cover
downward
3
Replace the cover.
Slide upwards
Listen for
a click to
ensure
connection.
Red
Wire
Click
Black
Wire
Red
Black
Installing the Base and Charger
Note: Use only the supplied AD-314 AC adapter for the base and
AD-310 or AD-1010 for the charger. Do not use any other AC adapter.
1
Connect each AC adapter to the DC IN 9V jack and
to a standard 120V AC wall outlet.
Do not use a power outlet
controlled by a wall switch.
Route the cord.
To AC outlet
To DC IN 9V
AC adapter (supplied)
To AC outlet
To DC IN 9V
AC adapter
(supplied)
2
Charge the handsets
at least 15-20 hours.
If the LED does not illuminate,
check to see that the AC
adapter is plugged in and
that the handset makes good
contact with the charging
contacts.
Make sure that the
charge/in use and
LEDs illuminate.
•
•
•
•
•
Comments to this Manuals