Uniden FP1355 Owner's Manual download pdf (Page 6)

WALL MOUNT

Your speakerphone can also be mounted on a wall plate (not included).

NOTE: To prevent the handset from falling out of the cradle while the

phone is hanging on the wall, you must switch both the handset

hook and the desk stand to their wall-mount positions.

On the base front, slide the handset hook out of the 1.

slot. Rotate hook 180 degrees and ip it from front

to back. Slide it back into the slot. It should extend

slightly; this extension ts into a slot on the handset.

Turn the base over. Press in on the tabs and remove the desk stand from 2.

the base back.

Rotate the stand 180 degrees, and insert the hooks marked 3. WALL into the

notches marked WALL. Press in on the tabs and snap the stand into place.

Connect the telephone line cord to the wall jack 4.

and the phone. If desired, wrap any excess cord

around the cord hooks.

Place the mounting slots over the wall plate pins 5.

and slide the base down to lock into place.

MOVE THE PHONE

If you need to move the phone after it has been

installed:

Disconnect the phone line.1.

Go to the electrical outlet and unplug the power adaptor.2.

Move the unit and phone line to the desired location.3.

Plug the power adaptor into an electrical outlet.4.

The display shows that the messages have not been erased.5.

Connect the phone line.6.

Reset time/date settings or wait for the next call to set them automatically.7.

FP1355 OM.indd 6 22/9/11 9:23:45 AM

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

No comments

Uniden FP1355 Owner's Manual Page 6