Uniden MHS235 Owner's Manual Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 46
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
E-31Uniden MHS235 Radio Owner’s Manual
change, select
Exit
. The radio returns to the channel list.
5. To restore a channel back to its original name, select the channel and choose
Default
.
6. When you are satised with the channel list, select
Exit
.

Due to its rugged design, your radio requires very little maintenance. However, it is a
precision electronic instrument, so you should follow a few precautions:
x If the antenna has been damaged, do not transmit except in an emergency situation.
Doing so may cause further radio damage.
x You are responsible for continued FCC technical compliance of your radio.
x Arrange for periodic performance checks with your Uniden dealer.

Problem Things to Try
The radio won’t turn on. Charge the radio.
The power LED on the charger
doesn’t turn on.
- Don’t use the charger when the ambient temperature is below 0° C (32°
F) or above 45° C (113° F).
- Make sure the charging contacts on the radio and charger are clean.
- Replace the battery.
The radio won’t transmit.
- Make sure you are not in Weather or Scan mode.
- Make sure you are not trying to transmit on a receive-only channel or
transmit at the wrong power level for this channel (see the channel lists
starting on page E-33.
- Check the battery power level; if it’s low, charge the battery before trying
to transmit.
- Make sure the duration of each transmission is less than 5 minutes.
I can’t hear anything from the
speaker.
Adjust the squelch level; it is probably too high.
Noise comes out of the
speaker all the time
Adjust the squelch level; it is probably too low.
I can transmit, but no one can
hear me.
Check your UIC channel settings: does the area you are in use different
channel assignments?
I’m not getting hazard alerts. Make sure Weather Alert Watch is turned on.
The display ashes, and I don’t
know why.
The channel number on the display will ash if the radio is in a Watch mode
or in Scan mode. Try turning off scanning, Weather Alert Watch, Triple
Watch, or Dual Watch beginning on page E-10.
Where can I nd my radio’s
serial number?
The serial number is on a plate inside the battery compartment.
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Comments to this Manuals

No comments