Uniden UIP200 - VoIP Phone User Manual download pdf (Page 17)

UIP200 User's Manual

Page 17 of 27

Rev. 1.0, © UAC, May, 2004

Step 2: Enter the destination telephone number.

Step 3: Press the

DIAL key to initiate the connection immediately. If you wait

approximately four seconds after you enter the last digit enter, the phone will

automatically connect.

Using On-Hook Dialing

You can also enter telephone numbers before picking up the handset or activating

the speakerphone (while the telephone is in standby mode).

Step 1: Enter the destination number.

Step 2: Pick up the handset or press

HEADSET/SPEAKER to make the phone go off-hook.

Step 3: Press the

DIAL key to initiate the connection; if you wait approximately four

seconds after you enter the last digit enter, the phone will automatically connect.

Receiving Calls

When there is an incoming call, the VISUAL RINGER LED will flash and the LCD

will display the number and name (if available) of the calling party. To answer the

incoming call with the handset, simply pick up the handset. To answer an incoming

call with the speakerphone or headset, leave the handset in the cradle and press the

HEADSET/SPEAKER key.

JOHN DOE

8175553198

Figure 5 LCD display when Receiving a Call

Adjusting the Volume

You can control the volume separately for the handset, the headset, the

speakerphone, and the ringer.

Changing the Handset Volume

Step 1: Pick up the handset.

Step 2: Press ▲ (UP) or ▼ (DOWN) to adjust the volume.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

No comments

Uniden UIP200 - VoIP Phone User Manual Page 17