Uniden WXI477 Specifications download pdf (Page 53)

Battery Replacement and Handling

With normal usage, your battery should last about one year. When the talk time becomes short, even after the bat-

tery is recharged, please replace the battery. A replacement Uniden adapter or battery may be purchased by calling

Uniden’s Parts department. See back cover page for contact information.

Replace the Rechargeable Handset Battery Pack

Remove the 4 screws holding the battery compartment with a screwdriver and take

off the battery cover. Remove the old battery pack in the battery compartment.

Plug the replacement battery connector (red & black wires) into the small, black

jack inside the battery compartment. (The connector notches t into the grooves

of the jack only one-way.) Match the wire colors to the polarity label in the battery

compartment, connect the battery and listen for a click to insure connection.

Make certain you have made a good connection by slightly pulling on the bat-

tery wires. If the battery connector is not securely connected, the handset will not

charge properly.

Before placing the battery cover back on the handset, make sure there is no for-

eign matter under the rubber seal located on the under side. By inserting the bot-

tom rst, place the battery cover back on the handset and tighten the 4 screws.

If the rubber seal appears warn, nicked, or dried out, replacement seals are avail-

able through the Uniden Parts Department. If you have questions regarding the in-

stallation of the battery pack and/or rubber seal, please call our Customer Service

Hotline at 1-800-297-1023.

Notes:

If there is any foreign matter on the rubber seal located on the under side of the

battery cover, the handset may not be water resistant.

The rubber seal should be kept clean and replaced every 2 years to ensure the

handset is water resistant even if the seal does not look worn.

•

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

No comments

Uniden WXI477 Specifications Page 53