Uniden DECT1080 User Manual download pdf (Page 13)

Using your phone

Make a call

1 Press the symbol is displayed. When

you hear the dial tone, dial the number you

want. The number is shown in the display.

After a short delay the call timer will start timing

the call.

2 Press to exit and return to standby.

Adjust the earpiece/speaker volume during a

call

1 Press or to adjust the volume.

There are six levels.

Make a call by pre-dialing

1 In standby, enter the number to be dialed.

The number is displayed.

You can enter numbers up to 24 digits long.

Press to delete any incorrect digits.

Press and hold to delete all digits.

2 Press to dial the displayed number.

Handset range

If the handset is too far away from the base,

during standby,

Searching

appears and the

symbol will flash. During a call you will hear a

warning tone. You will need to mover closer to the

base for clearer reception and to avoid being

disconnected.

Call timer

When you make or receive a call, a short while

after the line is connected the call timer will show

the duration of the call in the display in hours,

minutes and seconds. The call time will be

displayed for a further 5 seconds after you end

the call.

Handsfree

You can use handsfree to talk to your caller

without holding the handset to your ear. You can

speak into the handset microphone and listen over

the loudspeaker.

Handsfree also enables other people in the room

to listen in to the conversation.

[12]

UC01501BB_0 8/9/06 2:46 PM Page 12

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Comments to this Manuals

No comments

Uniden DECT1080 User Manual Page 13

Comments to this Manuals

Related products and manuals for Handset Cordless Phone Uniden DECT1080