Uniden DSS7815 Series Owner's Manual download pdf (Page 54)

Changing the Digital Security Code

Find Handset

Installing the Beltclip

The digital security code is an identification code used to connect the handset and the base

unit. Normally, setting the code is not necessary. In the rare situation that you suspect

another cordless telephone is using the same security code, you can change the code. To

change the digital security code:

1) De-register all the handsets you have (see “De-register the handset“ on page 26).

2) Register the handsets by following step 2-3 in “Registering the handset“ on page 15.

To locate the handset, press on the base when the phone is in standby mode.

All registered handsets beep for 60 seconds, and appears on the handset display.

To cancel paging, press any key on the handset or on the base.

Insert the beltclip into the holes on each side of the handset.

Press down until it clicks.

Pull either side of the beltclip to release the tabs from the holes.

find handset

Paging

To attach the beltclip

To remove the beltclip

Headset Installation

Your phone can be used with an optional headset. To use this

feature, insert the headset plug into the headset pack. Your phone is

ready for hands-free conversations. (Headset can be purchased

from a retailer or by visiting the web site. See page 56.)

! If the battery pack

is completely

drained, the

handset will not

beep when

paging.

[53]

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

No comments

Uniden DSS7815 Series Owner's Manual Page 54