Uniden WXI377 Owner's Manual download pdf (Page 10)

GETTING STARTED[ 10 ] www.uniden.com

Replace the rechargeable handset battery pack

1) Remove the 3 screws holding the battery compartment with a

screwdriver and take off the battery cover. Remove the old

battery pack in the battery compartment.

2) Plug the replacement battery connector (red & black wires)

into the small, black jack inside the battery compartment.

(The connector notches fit into the grooves of the jack only

one-way.) Match the wire colors to the polarity label in the

battery compartment, connect the battery and listen for a

click to insure connection.

3) Make certain you have made a good connection by slightly

pulling on the battery wires. If the battery connector is not

securely connected, the handset will not charge properly.

4) Before placing the battery cover back on the handset, make

sure there is no foreign matter under the rubber seal located

on the under side. By inserting bottom first, place the

battery cover back on the handset and tighten the 3 screws.

• If there is any foreign

matter on the rubber

seal located on the

under side of the

battery cover, the

handset may not be

water resistant.

• The rubber seal should

be kept clean and

replaced every 2 years

to ensure the handset

is water resistant even

if the seal does not

look worn.

Do not place a wet or

dirty handset in

the base.

Rubber Seal

UC393BH (WXI377) OM 5/2/03 4:18 PM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

No comments

Uniden WXI377 Owner's Manual Page 10