Uniden UBC3300XLT User Manual download pdf (Page 12)

ARC250 User Manual 1.10 - 12

2.3 Programming conventional frequencies:

You can enter frequencies directly in the grid. In the grid there is no cursor

shown. You can use BACKSPACE to make corrections in the grid.

If you click on a cell the current data is copied to the editor bar, in the editor

bar a cursor is shown (frequency and tag column only).

When you enter a frequency and you press ENTER the other cells of that line

are automatically programmed depending on your custom settings (default

channel data). You can customize the default data: select SETUP _ SETUP

DEFAULT DATA. A new window is shown:

In this window you set the default data that is put in the grid if you press

enter. All parameters that have the check box selected will be put in the grid.

By using this option the software will take care of programming default data.

Mode and step column: depending on the bandplan settings (section 6.2) the

software will automatically program data in the mode and step column.

Tip: programming your personal preferences in the default data and setup a

custom bandplan will save you time while programming new frequencies.

When you press <enter> the software will automatically go to the next cell.

2.4 Programming Trunk frequencies:

In ARC250 there is no difference between programming conventional and trunk

frequencies. A frequency is defined as a trunk frequency by setting the trunk

parameter to ON in the trunk column.

IMPORTANT: before you start programming trunk frequencies, make sure that

the correct trunk system type is selected. The software uses the information

from the trunk type settings to auto-correct data in the memory bank.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Uniden UBC3300XLT User Manual Page 12