Uniden DCX750 - DCX 750 Cordless Extension Handset Owner's Manual download pdf (Page 46)

2. On the Pendant

# The Pendant

is usually powered off. To turn it on, press and hold HELP for

more than 2 seconds.

1. Pick up the Pendant and press and hold

HELP

until you hear a confirmation

tone.

2. The Pendant will make an intercom call to all handsets (SSE35) or handsets

& base (SSE37).

3. Answer the intercom call on a handset or base.

# Take this opportunity to test the range of the Pendant. Always use the

Pendant within range of the base!

Test your Pendant

To end the call, press

HELP

for 2 seconds or place the Pendant back in the

cradle.

# Use the plastic pin (provided with

the Pendant) or a blunt-tipped object

like an uncurled paper clip to press

the REG button. Do not press the

REG button too hard using the PIN

(or paperclip) as it may damage the

button.

Please Note:

a) With the Pendant on the charger, use the plastic pin provided to press and

hold REG until the Status LED starts to blink blue and red.

b) Take the Pendant off the charger and press HELP for 2-3 seconds

until you hear a beep sound. Then use the plastic pin provided to press and

hold REG until the Status LED starts to blink blue and red.

# Make sure the Pendant is fully charged before registering to the base.

When the Pendant has been registered, a confirmation tone will sound.

# If the registration fails, press the

RESET switch with a pin and try

again.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

No comments

Uniden DCX750 - DCX 750 Cordless Extension Handset Owner's Manual Page 46