Uniden UBC220XLT User Manual download pdf (Page 25)

6, Insert the Battery

Pack into the scanner

so the label side is

showing. Make sure

it is seated within the

case before replacing

the Battery Cover.

7. Replace the Battery

Cover by putting the

two tabs in the

corresponding

opening and sliding it

upward until it locks in

place.

Location

■ If strong interference or electrical noise is received,

relocate the scanner or its antenna away from the

source of the noise. A higher elevation, if possible, may

provide better reception.

■ Do not use the scanner in high-moisture environments

such as the kitchen or bathroom.

■ Avoid placing the unit in direct sunlight or near heating

elements or vents.

Cleaning

■ Disconnect the AC Adaptor/Charger and/ remove the

battery from the unit before cleaning.

■ Clean the outside of the scanner with a mild detergent.

■ To prevent scratches, do not use abrasive cleaners or

solvents. Be careful not to rub the LCD window.

■ Do not use excessive amounts of water.

Repairs

Do not attempt any repair, The scanner contains no

serviceable parts. Contact the Uniden Technical Service

Division or take it to a qualified repair technician.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Hervé d'ÉTAT 10 Aug 2025 | 16:53:00

Bien

Uniden UBC220XLT User Manual Page 25