Uniden EXAI2980 Owner's Manual download pdf (Page 11)

GETTING STARTED

[ 9 ]

GETTING STARTED

Mounting the Base Unit on a Wall

SSttaannddaarrdd wwaallll ppllaattee mmoouunnttiinngg

This phone can be mounted on any standard wall plate.

1)Snap the wall mount adapter into the notches on the base.

2)Plug the AC adapter to the DC IN 9V jack.

3)Wrap the AC adapter cord inside the molded wiring channel as shown.

4)Plug the AC adapter into a standard 120V AC wall outlet.

5)Place the handset on the base and charge for 15-20 hours.

6)Plug the telephone line cord into the TEL LINE jack. Wrap the cord

inside the molded wiring channel as shown.

7)Plug the telephone line cord into the telephone outlet.

8)Raise the antenna to a vertical position.

9)Align the mounting slots on the base with the mounting posts on the

wall. Then push in and down until the phone is firmly seated.

SSeettttiinngg tthhee hhaannddsseett rreettaaiinneerr cclliipp ffoorr wwaallll mmoouunnttiinngg

1)On the base unit, pull the handset retainer clip out of the slot and rotate it clock-

wise 180 degrees.

2)Flip the retainer clip from front to back. Slide it back into the slot so that the lip

of the retainer is up and the

▼ is down. The retainer holds the handset in place.

DDiirreecctt wwaallll mmoouunnttiinngg

If you don’t have a standard wall plate, you can mount your phone directly to the wall. Before doing

this, consider the following:

• Avoid electrical cables, pipes, or other items behind the mounting location that could cause a

hazard when inserting screws into the wall.

• Try to mount your phone within 5 feet of a working phone jack to avoid excessive cord lengths.

• Make sure the wall material is capable of supporting the weight of the base and handset.

• Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall

material where the base unit will be placed.

1)Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart.

Allow about 1/8 of an inch between the wall and screw heads for mounting the phone.

2)Set the retainer clip if necessary.

3)Refer to steps 1 through 9 above to mount the telephone.

DO NOT use an

outlet controlled by

a wall switch.

If you have wall

mounted the base,

you have to remove

the beltclip to hang

the handset with

the display facing

forward.

EXAI2980A ReSIZE-ENG 7/31 7/31/01 16:50 Page 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 38 39

Comments to this Manuals

No comments

Uniden EXAI2980 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Telephones Uniden EXAI2980