Uniden EXAI2980 Owner's Manual download pdf (Page 34)

ADDITIONAL INFORMATION

[ 32 ]

The digital security code is an identification code used to connect the handset and the base unit. Normally, set-

ting the code is not necessary.

The first time you charge your handset, the security code is automatically set. (See "About the digital security code",

page 5.) In the rare situation that you suspect another cordless telephone is using the same security code, you can

change the code.

1)Remove the handset from the base unit. Press and hold

ppaaggee

on the base.

2)While the handset is emitting the paging sound, place the handset on the base unit holding

ppaaggee

. The paging

sound stops.

Leave the handset on the base for more than 5 seconds or until flashing stops.

A new random security code is set.

Changing the Digital Security Code

If the handset

battery pack is

completely

discharged or the

battery pack is

removed, the digital

security code will be

lost. If this happens,

a new security code

is set automatically

next time the

battery pack is

charged.

Installing the Beltclip

TToo aattttaacchh tthhee bbeellttcclliipp

Insert the beltclip into the

holes on each side of the

handset. Press down until it

clicks.

TToo rreemmoovvee tthhee bbeellttcclliipp

Pull both sides of the belt-

clip to release the tabs

from the holes.

Your phone may be used with an optional

headset, the Uniden HS910. To use this

feature, insert headset plug into the

headset jack. Your phone is ready for

hands-free conversations.

(Headset may be purchased by calling

the Uniden Parts Department or visiting

the web site. See Page 4.)

Headset Installation

If the beltclip is

attached, you can

only charge the

handset in the face

down position.

EXAI2980A ReSIZE-ENG 7/31 7/31/01 16:50 Page 32

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Comments to this Manuals

No comments

Uniden EXAI2980 Owner's Manual Page 34

Comments to this Manuals

Related products and manuals for Telephones Uniden EXAI2980