Uniden SSE17+1 Owner's Manual download pdf (Page 8)

1. Unpack all handsets, battery packs, and

battery covers. If you need to remove a cover,

press in on the notch and slide the cover down and off.

2. Line up the battery connector with the jack inside the

handset; the connector only fits one way.

3. Push the connector in until it clicks into place; tug

gently on the wires to make sure the battery is securely

connected.

4. Replace the battery cover and slide it into place.

5. Use an AC adaptor to connect the power jack on the base to a regular indoor (240V

AC) power outlet.

6. Place each handset in the base with the display facing forward. If the battery icon

does not begin cycling through levels, reseat the handset or connect the base to a

different outlet.

Install and Charge the battery

# Charge all handsets completely (about 15 hours) before using.

Test the Connection

1. Pick up each handset and press TALK/FLASH. You should hear a dial tone, and the

display should say Talk. (Press TALK/FLASH or END/CLEAR again to hang up.)

2. If there is noise or static, see “There’s a lot of noise or static on the line” on page 33

for tips on avoiding interference.

Set Up the Accessory Handset(s)

Using the Belt Clip

To attach the belt clip

1. Line up the holes on each side of the handset.

2. Insert the belt clip into the holes on each side of the handset.

3. Press down until it clicks.

To remove the belt clip

Pull either side of the belt clip to release the tabs from the holes.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

No comments

Uniden SSE17+1 Owner's Manual Page 8