Uniden UWS1117 Owner's Manual download pdf (Page 24)

Signal Level Icon Data Rate (kbps)

Frames per second (approx)

QVGA (Zoom) VGA (Normal)

Fair

543~725 8~12 2~4

Low

250~543 0~5 0~1

Zero

0~250 0 0

If the suggestions above don’t provide enough improvement in the the signal quality, you may

want to run the camera at QVGA or zoom mode. When the camera is in zoom mode, it sends fewer

pixels to the receiver, so the video performance is not as affected by the weak signal.

Noise or Static

The most likely cause of noise (flickering image) or static is interference. There are many common

sources of interference:

electrical appliances, especially microwave ovens

►

computer equipment, especially wireless LAN equipment ►

other radio-based wireless devices, such as cordless telephones ►

wireless controllers, or wireless headphones or speakers ►

large florescent light fixtures (especially if they give off a buzzing noise) ►

working motors (hair dryers, heater/air conditioners, water pumps) ►

If the static is only on 1 camera If the static is on all cameras

Check near the camera for one of the common ‑

interference sources.

Try moving the camera away from a suspected ‑

source, or try moving the suspected source so it’s

not between the camera and the receiver.

Try moving closer to the receiver. There is always ‑

more noise at the edges of the receiver’s range.

Check near the receiver for the source of ‑

interference.

Try moving the receiver away from a ‑

suspected source, or turn off the source if

possible.

Try raising the receiver’s antenna so it ‑

stands straight up.

UWS1117 OM.indd 24 28/9/11 10:21:29 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28

No comments

Uniden UWS1117 Owner's Manual Page 24