Uniden EZI996 Specifications download pdf (Page 10)

GETTING STARTED

www.uniden.com

C. Choose the Dialing Mode

Most phone systems use tone dialing which sends DTMF tones through the phone

lines. However, some phone systems (such as those in rural areas) still use pulse

dialing. The default setting is tone dialing. Depending on your dialing system, set the

mode as follows:

Place the switch in the tone position for tone

dialing, or the pulse position for pulse dialing.

If you are not sure of your dialing system, set for

tone dialing. Make a trial call. If the call

connects, leave the setting as is. Otherwise set

for pulse dialing.

D. Set the Visual Ringer Brightness

The visual ringer switch allows you to set the

brightness of the visual ringer LED on the base.

There are three options to choose from: high,

low and off. If you set the switch to off, visual

ringer LED never flashes.

• Make sure your

battery pack is fully

charged before

choosing the

dialing mode.

• If your phone system

requires pulse dialing

and you need to send

the DTMF tones for

certain situations

during a call, you may

switch over to tone

dialing. (Refer to

"Tone Dialing Switch-

over" on page 19.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

No comments

Uniden EZI996 Specifications Page 10