Uniden UBC800XLT Owner's Manual download pdf (Page 34)

Removing the Scanner from the DIN-E Sleeve

If you plan to connect other devices or wires to the radio, such as a GPS unit, at a

later time, you should plan to remove the scanner from the DIN-E sleeve. This is

easily done using the Removal Keys.

Fully insert both Removal Keys into the slots on the left and the right edges of the

radio’s dress panel. You cannot remove the radio if only one key is available. Press

in fully and the radio will unlock from the sleeve making withdrawal from the sleeve

possible. Store the keys in a safe place for future use.

Mounting Using ISO Technique

Some vehicles can take advantage of another approach to mounting a radio in a

vehicle, called the ISO technique. However, this technique requires a very detailed

and thorough knowledge of the technique. Therefore, we strongly suggest that if

you have any doubt about your experience and abilities, please consult with a

professional installer who is familiar with the ISO approach to radio installation.

To begin the process, it is first necessary to remove the scanner's outer metal

sleeve from the inner chassis. Unthread the four screws in the rear of the unit.

Slide the cover toward the rear and off. Once the sleeve is removed, you will see

threaded, metric machine screw holes on either side of the chassis cabinet.

Uniden does not supply these screws. Their diameter, length, and screw type

should be chosen by a qualified installer based on the internal vehicle bracket

which will be used in securing the scanner chassis.

Removal Keys

UB356ZH.fm Page 34 Wednesday, December 19, 2007 11:28 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 143 144

No comments

Uniden UBC800XLT Owner's Manual Page 34