Uniden UBC800XLT Owner's Manual download pdf (Page 56)

Important: Start with a high baud rate setting. If, during transfer, you get an error

message, reduce the setting and start again until you get reliable, complete

transfer of data.

Volume/Squelch with PC Control

If you use a PC to control the scanner, and you change the scanner’s volume or

squelch setting using the PC, the scanner ignores the front-panel control’s current

setting. However, if you later change the volume or squelch setting using the

front-panel control, the scanner uses the control’s setting (i.e. the scanner pays

attention to the last method used).

Wired Cloning

Using the scanner in a cloning setup lets you transfer programmed data directly

from a source or master UBC800XLT to a target or slave UBC800XLT. Wired

cloning between other models to the UBC800XLT is not possible.

[MENU]

  Wired Clone F

 Master or Slave (select one as the master and one as the slave)

To clone (transfer) data directly from one UBC800XLT scanner to another

UBC800XLT scanner, you must first connect the scanners to each other using the

included connection cables and a DB9 null modem adapter and for the rear port, a

DB9 gender changer (neither included), available at most computer stores. Then

you must set one scanner as the source and the other as the target.

1. Select the Front Port for the Master. Select the Rear Port for the Slave or vice

versa.

2. Plug the 9-pin serial connector into the unit designated as the Rear Port.

3. Plug the smaller connector into the front port of the unit designated as Front

Port.

Connected as

shown, and with

both ports

correctly selected,

no other hardware

is needed.

UB356ZH.fm Page 56 Wednesday, December 19, 2007 11:28 AM

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 143 144

No comments

Uniden UBC800XLT Owner's Manual Page 56