Uniden UBC800XLT Owner's Manual download pdf (Page 35)

Setting Up Your Scanner

Once the original radio is removed from the vehicle dash and the fit of the scanner

is correct, be sure to connect all the power, audio, antenna, and any other cables

or wires, to the scanner before the scanner is secured.

The following illustration is a typical example of the ISO technique and the general

side mounting screw holes often encountered. It does not actually represent your

vehicle or your vehicle’s mounting bracket. Only a professional installer will be able

to determine the best and correct approach.

Removing the Display Sticker

Before you use the scanner for the first time, remove the protective plastic film

over the display.

Connecting an Optional Antenna

The scanner’s BNC connector makes it easy to connect a variety of optional

antennas, including an external mobile antenna or outdoor base station antenna.

Note: Always use 50- or 75-ohm, RG-58, or RG-8, BNC terminated coaxial cable

to connect an outdoor antenna. If the antenna is over 50 feet from the scanner, use

RG-8 low-loss dielectric coaxial cable. Cable loss increases with higher frequency.

Connecting an Earphone/Headphone

For private listening, you can plug a

/8-inch (3.5 mm) mini-plug earphone or

headphones (not supplied) into the headphone jack on the front of your scanner.

This automatically disconnects the internal speaker. See “Earphone Warning” at

the front of the manual for important information about using an

earphone/headphone.

Internal Bracket

Dash

UB356ZH.fm Page 35 Wednesday, December 19, 2007 11:28 AM

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 143 144

No comments

Uniden UBC800XLT Owner's Manual Page 35