Uniden UBCD996T Owner's Manual download pdf (Page 32)

To secure the radio, by means of the mounting bracket, to a surface, follow the steps

below:

1. Attach the four protective rubber feet to the mounting bracket when you casually

use the scanner on a flat surface. Should you desire to permanently mount the

scanner, remove the feet and use wood screws through the bracket as described

in Steps 2 and 3.

2. Use the bracket as a template to mark positions for the two mounting screws.

3. At the marked positions, drill holes slightly smaller than the screws.

4. Align the bracket with the threaded holes on the sides of the radio case so the

bracket is beneath the radio. Secure the bracket using the two threaded knobs.

Never overtighten the knobs.

Once the radio is positioned, connect it to a source of AC power using the supplied

AC adapter. Insert the barrel of the AC adapter to the jack on the

rear, upper right side of the radio marked .

13.8V, 700 mA

UBCD996T

MOUNTING WOOD SCREWS

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 32