Uniden UBCD996T Owner's Manual download pdf (Page 89)

Auto

NFM

WFM

Auto

Program System

Edit Group

Edit Channel

Set Attenuator

Off Off

Program System

Edit Group

Edit Channel

Set Priority

— the scanner uses the default modulation for the channel. The default setting

is .

— the scanner uses AM (amplitude modulation) for the channel.

— the scanner uses FM (frequency modulation) for the channel.

— the scanner uses narrowband FM for the channel.

— the scanner uses wideband FM for the channel.

(Broadcast) the scanner uses FM Broadcast for the channel.

This setting controls the modulation method used for the channel. In most cases, if

you leave this set to , the scanner automatically selects the correct modulation

type for the channel you are programming.

Select a conventional system

(existing site)

Select a channel group

Select a channel

This setting controls whether the scanner attenuates signals on this channel. Select

your setting, then press .

— the channel is attenuated by about 20 dB.

— the channel is not attenuated. The default setting is .

You can also toggle this setting by holding on the channel and pressing then

within 2 seconds.

Select a conventional system

Select a channel group

Select the channel

—

[MENU]

[7]

[MENU]

Setting Channel Attenuation C

Setting Channel Priority C

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 89