Uniden UBCD996T Owner's Manual download pdf (Page 81)

Select a VHF or UHF site

You can enter up to 3 band plans. Select the plan to enter or edit, then follow the

prompts to enter the Base Frequency, Channel Step, and Channel Offset for the site.

The UBCD996T includes two operation modes for P25 systems: explicit mode and

implicit mode channel assignment. Explicit mode systems include all information

needed to determine voice frequencies on the control channel. You must supply the

system’s band plan for intrinsic systems for the scanner to correctly determine voice

frequencies.

To set the band plan for a P25 system:

Then, follow these steps:

the Band Plan table entry you want to edit and .

Enter the base frequency for the table entry and .

Enter the spacing for the table entry (in kHz) and .

Repeat 1-3 for additional table entries.

For Explicit mode systems, leave all entries blank.

There is no way to determine the correct entries using the scanner (other than

trial and error). You must get this information from another source. Uniden

Australia Pty Ltd and Uniden NZ Ltd does not have this information.

Select a trunked system

Select a non-P25 site

Edit Band Plan

[MENU] Program System

Edit Site

Edit Band Plan

Program System

Edit Site (current)

Set C-Ch Only

Setting P25 Band Plans (P25 Only)

Select a Motorola Type II/P25 system

Select a P25 site

Notes:

[MENU]

Setting Control-Channel Only Mode M (except for P25)

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 81