Uniden UBCD996T Owner's Manual download pdf (Page 37)

Once the original radio is removed from the vehicle dash and the fit of the scanner is

correct, be sure to connect all the power, audio, antenna, and any other cables or

wires, to the scanner before the scanner is secured.

The following illustration is a typical example of the ISO technique and the general

side mounting screw holes often encountered. It does not actually represent your

vehicle or your vehicle’s mounting bracket. Only a professional installer will be able

to determine the best and correct approach.

Before you use the scanner for the first time, remove the protective plastic film over

the display.

The scanner’s BNC connector makes it easy to connect a variety of optional

antennas, including an external mobile antenna or outdoor base station antenna.

Always use 50- or 75-ohm, RG-58, or RG-8, BNC terminated coaxial cable to

connect an outdoor antenna. If the antenna is over 50 feet from the scanner, use

RG-8 low-loss dielectric coaxial cable. Cable loss increases with higher frequency.

For private listening, you can plug a / -inch (3.5 mm) mini-plug earphone or

headphones (not supplied) into the headphone jack on the front of your scanner.

This automatically disconnects the internal speaker. See “Earphone Warning” at the

front of the manual for important information about using an earphone/headphone.

Removing the Display Sticker

Connecting an Optional Antenna

Connecting an Earphone/Headphone

Note:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 37