Uniden UBCD996T Owner's Manual download pdf (Page 60)

2. While pressing , , and at the same time, turn on power.

At that point anything you have programmed is gone.

You are given a last opportunity to keep the factory programmed data when you see

the question:

You can connect your scanner, by means of the

supplied cable, to a personal computer to

download data from the computer to the memory of

the scanner. Before you proceed, you must first set

the scanner’s communications speed as described

in the previous section. In addition you will need a

copy of Uniden Advanced Scanner Director

software. You can download the software from

in the Customer Service

Downloads link.

Start with a high baud rate setting. If, during transfer, you get an error

message, reduce the setting and start again until you get reliable, complete transfer

of data.

If you use a PC to control the scanner, and you change the scanner’s volume or

squelch setting using the PC, the scanner ignores the front-panel control’s current

setting. However, if you later change the volume or squelch setting using the front-

panel control, the scanner uses the control’s setting (i.e. the scanner pays attention

to the last method used).

Using the scanner in a cloning setup lets you transfer programmed data directly from

a or UBCD996T to a or UBCD996T. Wired cloning

between other models to the UBCD996T is not possible.

or (select one as the master

and one as the slave)

[2] [9] [HOLD]

If you do not say Yes, the scanner is totally empty.

Important:

master slave

[MENU]

Restore Preprogram List? Yes=”E”/”No= ”.”

Wired Clone Master Slave

Connecting Your Scanner to a Personal Computer

Wired Cloning

www.uniden.com.au

source target

Volume/Squelch with PC Control

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 60