Uniden UBCD996T Owner's Manual download pdf (Page 79)

Note:

[MENU]

Note:

+ [7]

[MENU]

If you select Control Channel Only mode (see “Setting Control-Channel Only

(Motorola Systems Only)” on Page 81), you only need to enter the frequency(s) that

can be assigned as the control channel. Most frequency lists usually indicate which

of the frequencies are the control channel frequencies. Otherwise, you must enter all

of the frequencies.

Select a trunked system

Select a Site

— the scanner uses the default modulation for the frequency band.

— the scanner uses FM (frequency modulation) for the frequency band.

— the scanner uses narrowband FM for the frequency band.

The default setting is .

This setting controls the modulation method used for the frequency band. In most

cases, if you leave this set to , the scanner automatically selects the correct

modulation type for the system you are programming.

Enable Attenuation if you are near strong signal sources. Attenuation can help

reduce interference and desensitization that strong signals create. You can also turn

this setting on or off by holding on a trunked system, then pressing .

Select a trunked system

Select a Site

— the attenuator is off.

— site frequencies are attenuated by about 20 dB.

Select a trunked system

Setting Site Modulation ML

Setting Site Attenuation MESL

Setting Site Lockout MESL

Program System

Edit Site

Set Modulation

Auto

NFM

Auto

Program System

Edit Site

Set Attenuator

Off

Program System

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 147 148

No comments

Uniden UBCD996T Owner's Manual Page 79